320×480 IPS TFT LCD Designed for Raspberry Pi 3.5inch RPi LCD (B) Supports Any Revision of Raspberry Pi (Directly-pluggable)

480x320 hardware resolution, software configurable up to 1920x1080 Resistive touch control
$39.99
$24.99
PRICE BREAKS - The more you buy, the more you save
Quantity 3+ 10+
Price $22.99 $19.99

320×480, 3.5 inch Touch Screen IPS TFT LCD Designed for Raspberry Pi
Features
320×480 resolution
Resistive touch control
Supports any revision of Raspberry Pi (directly-pluggable)
Drivers provided (works with your own Raspbian/Ubuntu directly)
IPS technology, high quality and perfect displaying from very wide viewing angle
Size perfectly fits the Pi
High quality immersion gold surface plating
Supports Raspbian system, enables your system to:
Take photos by touching (up to 17 camera modes)
Support software keyboard (system interaction without keyboard/mouse)
3.5inch RPi LCD (A) and 3.5inch RPi LCD (B) are hardware compatible with each other (uses different driver), and can be mutually substituted in most cases. (A) for low cost ver. while (B) for IPS ver. with better displaying.

Development Resources
Wiki : www.waveshare.com/wiki/3.5inch_RPi_LCD_(B)

FAQ
Why the LCD doesn't work with my Raspbian?
To use the LCD with the Raspberry Pi official image, driver should be installed first. Please refer to the user manual.
However, for the first testing, you may want to use our provided image directly.
Why the LCD still doesn't work with the Waveshare provided image?
Make sure the hardware connection is correct and connects fine.
Make sure the image in TF card is burnt correctly.
The PWR will keep on and the ACT will keep blinking when the Raspberry Pi starts up successfully, in case both of the two LEDs keep on, it is possible that the image was burnt incorrectly OR the TF card was in bad contact.
Which power supply should I use?
It is recommended to use a 5V/2A power adapter for the Raspberry Pi other than USB connection, otherwise the Pi may failed to start up because the PC's USB port might have not enough power.
For large size LCDs, say, 10inch diagonal or more, another stand-alone power adapter is also required to provide power to the LCD.
For more info, please check the wiki page.